4 VeniceU16/VeniceU24/VeniceU32 Quick Start Guide 5VeniceU16/VeniceU24/VeniceU32 Quick Start Guide
Using USB with a VeniceU console
This is the Quick Start Guide for the VeniceU consoles. It shows you how to get
your console and PC/Mac ready to use USB.
The VeniceU console has been tested and veried for USB use with the following
computer operating systems: a PC running Windows® 7 and a Mac running
OS® X (version 10.7 or later). However, we cannot guarantee correct USB
operation on any other computer operating system.
For full details of console and USB operation, see the VeniceU Operator Manual.
Windows 7 operating system
This section shows how to install USB on a PC running the Windows 7
operatingsystem.
To install the USB device driver on your PC
◊ Do not connect the USB cable to the PC before installing the
device driver.
◊ Important: Before installing the USB device driver, we recommend
that you make sure it is the latest version by checking the
www.midasconsoles.com website. This is important, as you may not
be able to use USB operation properly with an older version of the
device driver.
(1) Visit midasconsoles.com to download the latest drivers
(2) Launch MidasFWInstaller.exe to start the setup wizard. In the Setup –
MidasFW window, click Next.
(3) In the User Account Control dialog box, click Yes.
(4) In the “Welcome ...” screen of the Setup dialog box, click Next.
(5) In the “Choose Install Location” screen of the Setup dialog box, choose the
destination of the USB driver and click Install.
The installation will begin.
(6) During the installation procedure the following dialog box will appear.
Plugthe USB cable into the VeniceU console (type B connector) and into your
PC (type A connector). Then switch on the console and click OK in the
dialogbox.
(7) The installation procedure should continue. After the installation has been
completed successfully, click Next.
(8) In the “Completing ...” screen of the Setup dialog box, click Finish.
(9) The Archwave icon should appear in the task bar at the lower-right
corner of the screen.
You are now ready to use USB with the VeniceU console.
The default settings of the USB software you have just installed should
be adequate for use. However, if you want to change these settings,
open the Archwave USB Driver Control Panel by clicking on the Archwave icon
(shown above).
If you encounter unwanted audio artefacts, such as humming, this is probably an
indication of ground loop problems—refer to the Operator Manual for details.
Mac operating system
USB, when used with a Mac running OS® X (version 10.7 or later), is a ‘plug and
play’ device. So, unlike on a PC running Windows® 7, there is no need to install a
USB device driver.
If you encounter unwanted audio artefacts, such as humming, this is probably an
indication of ground loop problems—refer to the Operator Manual for details.
Mac and OS X are trademarks of Apple Inc. Windows is a registered trademark of Microsoft Corporation in the United States and other countries.
(8 Seiten)
(1 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern